Delta Electronics TP06 Manuale di Installazione

Mode TigerDimmable Power UnitMODE LIGHTING (UK) LIMITEDThe Maltings, 63 High Street, Ware, Hertfordshire, SG12 9AD, England.Tel: +44 (0) 1920 462121 e

This unit is to be wired by a suitably qualified electrician in accordancewith National Wiring Regulations and other applicable Re

OUTPUT WIRING TP-06-09 (9 CHANNEL)CHANNEL OUTPUT TERMINALS9 Live output terminals (6.6 amp max.).9 Neutral output terminals (6.6 amp

10EXTERNAL CONNECTORS (top plate)CONTROL WIRING (LOW VOLTAGE)RS-232 9 way D connector - for future use.5 Pin XLR chassis socket for DMX

11CONTROL MODULE SETTINGSDisplay showing start address.For future use.Push button increment 100's for start address.Push button in

12POWER MODULE FUNCTIONSTWIN MODULE used in 6 channel model TP-10-06Heatsink and mounting bracketRFI noise suppression chokesChannel

13INDICATOR IDENTIFICATIONThe three neons shown indicate when the phase input is live.Phase 1Phase 2Phase 3The three green neons show

TECHNICAL SPECIFICATION TP-10-06 (6 CHANNEL)POWER Voltage 230V AC nominal. (207V - 253V), 50Hz.SUPPLY (110V 60Hz AC nominal available

TECHNICAL SPECIFICATION TP-06-09 (9 CHANNEL)POWER Voltage 230V AC nominal. (207V - 253V), 50Hz.SUPPLY (110V 60Hz AC nominal available

16 Periodically inspect the wiring for damage.Ensure the ventilation holes have not become covered or blocked with dust.Check overall

Mode Lighting (UK) Limited was established in 1970 as a manufacturer ofelectronic componets for the lighting industry. Mode has an enviablereputation

Page1.2.3.4. 5.6.7.8.9.10.11.12.13.14.15.16.17.ContentsIntroductionInstallation procedureMechanical fixingIdentification of terminals TP-10-06

INTRODUCTION2FOUNDATION: Mode was established in 1970 as an Original Equipment Manufacturer in Hertfordshire, England. Mode designs and

3INSTALLATION PROCEDURE1. Remove all packaging.2. Read instructions and retain for future reference.3. Fit unit to wall and observe spa

MECHANICAL FIXING Mark positions, drill holes and fit screws to wall, see diagram below. Dimensions in millimetres.Hang unit on screw

IDENTIFICATION OF TERMINALS TP-10-06 (6 CHANNEL)5PHASE INPUT NEONSDMX / SCENARIOINPUT TERMINALSANALOGUE INPUT /OUTPUT TERMINALSSTART ADD

IDENTIFICATION OF TERMINALS TP-06-09 (9 CHANNEL)PHASE INPUT NEONSDMX / SCENARIOINPUT TERMINALSANALOGUE INPUT /OUTPUT TERMINALSSTART ADDR

MAINS SUPPLY WIRINGCONNECTIONConnect three live input feeds using wire of between the values stated above and in accordance with the